Operator`s manual

Input: 9600 LFfill: 0 Width: 300 Parity: None
Output: 9600 CRfill: 0 Page: 66
Terminal Characteristics
Interactive Echo Type_ahead No Escape
No Hostsync TTsync Lowercase Tab
Wrap Scope No Remote Eightbit
No Broadcast No Readsync Form Fulldup
No Modem No Local_echo No Autobaud No Hangup
No Brdcstmbx No DMA No Altypeahd Set_speed
Line Editing Overstrike editing No Fallback No Dialup
No Secure server No Disconnect Pasthru No Syspassword
No SIXEL
Graphics
No Soft
Characters
No Printer Port Numeric
Keypad
No ANSI_CRT No Regis No Block_mode No Advanced_
video
No Edit_mode No DEC_CRT No DEC_CRT2 No DEC_CRT3
This can be accomplished by the DCL command:
$ set term txa1: /pasthru/speed=9600/etc
Note
PASTHRU SHOULD ALWAYS BE SET.
4. Set the terminal line to support a spooled device by issuing the DCL
command:
$ set dev/spool=(queue_name) txa1:
where queue_name is the name of the queue.
5. Start the queue by issuing the DCL command:
$ ini/que/start/terminal queue_name/on=txa1:
The LG31 can now be used.
2.6.3 RSX Settings
The terminal characteristic PASTHRU should be set.
2.6.4 RT-11 Settings
A command of the form ASSIGN TT1: LP: should be issued. This
assumes a multi-terminal system. Refer to the RT-11 System User’s
Guide.
INSTALLATION AND CHECKOUT 2–17