Operator`s manual

2.2.2 Unpacking Procedure
Use the following procedure and illustrations when unpacking the LG31
printer. Save the red shipping screws, blocks, and brackets for reship-
ment.
1. Cut and remove the four shipping straps from shipping pack (see
Figure 2–1).
2. Remove the country kit from the top of the printer carton.
3. Remove the screws holding the two tabs from the side of the carton
using a 7/16" AF Wrench (see Figure 2–1).
Figure 2–1: Cut Straps and Remove
RE_UK00284M_89
INSTALLATION AND CHECKOUT 2–3