Operator`s manual

Figure 6–7: Margin Adjust Knob
UPPER LEFT
PAPER TRACTOR
PAPER GAP
ADJUSTER
MARGIN
ADJUSTMENT
KNOB
PAPER
THICKNESS
SCALE
PAPER TENSION
ADJUSTMENT
LEVER
RE_UK00966A_89
6.7 Buffer Clear
To clear the buffer, carry out the procedure in Chapter 4, Section 4.5.7.
6.8 Low Paper Printing
The low paper switch is activated when 21.3 cm (8.4 in) of paper remains
in the printer. At this point, a choice may be made to discontinue printing
or enter the Low Paper Print (LPP) mode and continue printing for a
maximum of 21.3 cm (8.4 in). During the LPP mode, the key (6) PAPER
REV is inoperative, but works normally during paper out [ P O ] and
striker bar open [ S b o], so that Top Of Form can be set. The low paper
printing procedure is shown in Table 6-1.
Note
Setting the paper tension adjust lever to 6 (minimum gap) to
increase paper tension will improve printout during low paper
printing.
6–10 PRINTER OPERATION