Specifications

Ordering Information
KWVll-SF
UDIP-BAI
UDIP-KB
UDIP-TA
Performance
Clock
Crystal oscillator
Output ranges
Oscillator accuracy
Other sources
Schmitt-Trigger
input signals
No. of inputs
Input range
Triggering range
Triggering slope
Source
Response time
Hysteresis
Characteristics
Clock output
Signal
Output pins
Function
KWVll field-installed kit
Universal data interface panel (UDIP) mounting
box
Universal data interface panel (UDIP) for KWVll-
S
Tabletop enclosure
10-MHz
base frequency
1 MHz,
100 kHz, 10 kHz, 1 kHz, and 100 Hz
0.01%
Line frequency or input at Schmitt Trigger
2
±30 V (maximum limits)
-12 V to +12 V (adjustable)
Positive
or negative, switch-selectable
User device
Depends on input waveform and amplitude; for
TTL logic levels, typically
600 nanoseconds
Approximately
0.5 V, positive and negative
Single-ended input with 100-Kn impedance to
ground
CLK OV L (clock overflow, asserted low)
J1 pin 5 and CLK OVFL tab
Time base selection from an internal crystal-
controlled frequency,
an input at ST1, or a line
frequency
at BEVNT bus line
1 Both a UDIP mounting box and an interface must be ordered when installing a new option.
Option Specifications 2-57