Specifications

5–10
Adjustments
Hammer Tip Alignment (Figure 5–4)
IMPORTANT
You must use the alignment tool to correctly align the hammer tips. This
procedure cannot be done accurately by hand.
1. Put the hammer bank in the service position. (See page 5–2.)
2. Loosen the screw (1) of the hammer spring (2) to be aligned.
3. Place the hammer alignment tool (3) (P/N
FD–28262–01) over the
hammer tips. Move the hammer spring until the tip is in an appropriate
hole in the alignment tool.
4. Torque the screw (1) to 6 to 9 in–lbs.
5. Remove the alignment tool.
6. Return the hammer bank to the operating position. (See page 5–6.)