Specifications

6–35
Replacement Procedures and Parts
Shuttle Motor (FD–32538–01)
1. Unplug the printer power cord from the AC receptacle to insure that
there are no hazardous voltages present while servicing this equipment. It
is also recommended that an anti–static wrist strap (29–26246–01) be
worn, especially while servicing logic components.
2. Remove the paper supply from the print station and tractors.
3. Remove the lower paper guide (Figure 6–7, page 6–40, item #16), this
will allow access to the shuttle motor.
4. Remove the cam cover (Figure 6–7, page 6–40, item #4), and the paper
feed belt guard (Figure 6–9, page 6–44, item #4).
5. Remove the shuttle motor belt guard by removing one (1) bottom 5/16”
screw, and one (1) 5/16” nut/bolt pair from the top, being careful not to
drop the nut into the printer. This cover fits tightly, and will need to be
flexed for removal.
6. Remove the shuttle motor power and signal cables from their
mate–n–lock connectors, and the four (4) shuttle motor mounting nuts,
(7/16) to free the motor from its mounting plate.
7. Install the new shuttle motor, while looping the belt around the shuttle
motor sprocket prior to installing the four shuttle motor mounting bolts.
Reconnect the power and signal cables, and adjust the shuttle belt tension
(page 5–36).
8. Reverse the remaining removal steps to complete the shuttle motor
replacement.