Specifications

6–28
Replacement Procedures and Parts
Paper Motion/Out Detector (29–30805–01)
1. Unplug the printer power cord from the AC receptacle to insure that
there are no hazardous voltages present while servicing this equipment. It
is also recommended that an anti–static wrist strap (29–26246–01) be
worn, especially while servicing logic components.
2. Remove the paper supply from the print station and tractors. Remove the
paper chains, paper tent, and wire paper guide.
3. Working from the rear of the paper cabinet, remove the three (3) 5/16”
screws that hold the machined and front paper guide assembly in place.
(See Figure 6–10, page 6–46, items #1 and #2.)
4. Disconnect the mate–n–lock connectors, and cut the necessary tie–wraps
to allow the removal of the entire assembly.
5. To remove the paper motion/out switch assembly, remove the two
(2)1/4” screws securing it to the machined and front paper guide
assembly.
6. Reverse the removal procedure to re–install the paper motion/out switch
assembly. When assembly is complete, adjust the Paper Out Switch
(page 5–18).