Specifications

6–27
Replacement Procedures and Parts
Paper Feed Motor and Belt (FD–30894–01) (FD–13861–01)
1. Unplug the printer power cord from the AC receptacle to insure that
there are no hazardous voltages present while servicing this equipment. It
is also recommended that an anti–static wrist strap (29–26246–01) be
worn, especially while servicing logic components.
2. Remove the paper supply from the print station and tractors.
3. Remove the lower paper guide (Figure 6–7, page 6–40, item #16), four
(4) 1/4” screws. This will allow access to the paper motor when
tightening the belt.
4. Remove the Paper Feed Belt Cover.
5. Loosen the four (4) 5/16” nuts which secure the paper feed motor. (See
Figure 6–10, page 6–46.)
6. Slide the new belt onto the paper tractor shaft sprocket, and the paper
feed motor sprocket, and adjust the belt tension (page 5–16).
7. If the paper feed motor is to be replaced, remove the four (4) 5/16” nuts
which secure the paper feed motor, disconnect the power and signal
cable connector, and remove the motor.
8. Install a new paper feed motor using the 5/16” hardware, and adjust the
belt tension (page 5–16).
9. Reverse the removal steps to replace the paper feed belt cover and lower
paper guide.