Specifications

6–10
Replacement Procedures and Parts
8. Re–install the counterweight assembly:
e. To install the counterweight assembly first remove the rear base plate
allen screw which was loosened during the removal procedure.
Position this screw into the base plate rear slot, and with the allen
wrench inserted into the screw, slide the counter weight assembly
into place, starting the screw into the printer deck threads. Do not
tighten this screw at this time.
f. Next replace the the counterweight allen screw which secures the
right spring seat. (Right side of printer deck) Do not tighten this
screw at this time.
g. To complete the installation, replace the final front base plate allen
screws, and then tightened all 4 screws.
9. Insure that the shuttle belt tension adjustment is completed as described
in Chapter 5., and then replace the lower paper guide.
10. To insure proper shuttle performance, the shuttle and counterweight
preload and spring adjustments, and the MPU gap and phase adjustments
found in chapter 5. should be performed.