Specifications

6–5
Replacement Procedures and Parts
Cabinet Cooling Fan (29–29294–01)
1. Unplug the printer power cord from the AC receptacle to insure that
there are no hazardous voltages present while servicing this equipment. It
is also recommended that an anti–static wrist strap (29–26246–01) be
worn, especially while servicing logic components.
2. Open the printer cover to gain access to the upper cooling fan, located at
the right rear of the printer. (See Figure 6–6, page 6–38).
3. Disconnect the power mate–n–lock connector from the fan., and remove
the two (2) 1/4” retaining screws. (See Figure 6–16, page 6–58.)
NOTE: Two of the four screws are used to attach the grill to the fan, these
must be removed and used with the new fan.
4. The fan will now be free of its housing. Reverse these steps for new fan
replacement.