Specifications

5–20
Adjustments
f. Press R/S or ENTER to start the test. When the Paper Out condition
occurs, remove the paper from the tractors, and determine the
distance to the edge of the paper by counting the number of dot rows
from the end of the comb to the perforation (if short), or the dot rows
beyond the perforation (if long).
NOTE: Use the long bars for counting the dot rows quickly. The distance
between long bars is 4 dot rows. You can tear off a small piece of
the comb pattern from the beginning of the pattern to help you
determine the dot rows required to reach the perforation (or back up
to it).
• If the comb pattern is short or long, go to substep g.
• If the comb pattern succeeds in just meeting the edge of the
paper, insert new paper, close the forms thickness lever, and go
to Step 13.
g. Press CLEAR.
h. Press . The current emulation appears on the display.
i. Press . “Off–Line Print Engine” appears on the LCD.
j. Press . “Print Engine Unidirectional” displays.
k. Press . “Print Engine Paperout Adjust” displays.
l. Press . “Paperout Adjust xxx dots * ” appears.
m. Increase (for short test) or decrease (for long test) the Paper Out
Adjust value by the number of dot–rows you counted in Step 12.f.
For example:
• If the distance is short by the distance between 2 long combs,
add 4 to the Paper Out Adjust value (using the  switch).
• If the distance is long by half the distance between 2 long combs,
subtract 2 from the Paper Out Adjust value (using the  switch).
Press ENTER to select the new value as the active value. An asterisk
(*) will appear next to it on the display.
n. Load the paper and close the forms thickness lever.