User`s manual

6–9Routine Service and Diagnostics
Fault Messages
If a fault condition occurs in the printer, the status lamps on the message
display flash on and off and the first line of the display indicates “Fault
Condition.” The second line of the display indicates the specific fault. Fault
messages are summarized in Table 6–1.
Displayed faults fall into one of two categories:
• Operator correctable.
• Field service required—indicated by an asterisk [ * ] after the fault
message.
After correcting a displayed fault, press the CLEAR switch to continue
printing. If the fault message reappears, contact your authorized service
representative.
Fault Messages Requiring Field Service Attention
An asterisk ( * ) following a fault message means the attention of an
authorized field service representative is required.
Before you call the service representative, do two things to try to clear the
fault:
1. Set the printer power switch to off, wait fifteen seconds, then turn the
printer on again. Run your print job again. If the message does not
appear, it was a false indication and no further attention is required.
2. If the message reappears, press the CLEAR switch. If the message goes
away, it was a false indication and no further attention is required. If the
message reappears, call your authorized service representative.
Table 6–1 shows the fault messages and offers suggestions for corrections.