User`s manual

4–4 Printer Configuration
Configuration Procedure
Use the following procedure to configure the printer from the control panel:
1. Obtain a configuration printout (page 4–2).
2. Determine the parameter values that must be changed to meet your
requirements. The Configuration Diagram (page 4–8) shows all menus
and parameter values.
3. Take the printer off–line by pressing the ON LINE switch. Open the
printer cover.
NOTE: The ENTER switch must be unlocked to change a configuration
value. (You can examine—but not change—the current
configuration by leaving the ENTER switch locked.)
4. Press UP and DOWN simultaneously to unlock the ENTER switch.
“Unlocked” appears briefly on the message display. (If “Locked”
appears, simply press UP and DOWN again.)
5. Locate the desired menu by pressing DOWN and then NEXT or PREV
until the menu name appears on the display. Use the Configuration
Diagram (page 4–8) as your road map.
6. Locate the desired value in the menu by pressing DOWN, then pressing
NEXT or PREV until the desired value appears on the display.
7. Press ENTER when the desired value shows on the message display.
(An asterisk [ * ] will appear next to the value, indicating it is now the
active value.)
8. Press UP, then NEXT or PREV to move to the next desired menu.
Repeat steps 6 and 7.
9. After you have made all required parameter changes, press CLEAR.
The display goes to “Off–line Emulation.” Press NEXT until “Off–line
Save Config” displays. Press ENTER. This saves the parameter values
as the power–up default values. (See “Saving Configuration Values” on
page 4–5.)
10. Lock the ENTER switch by pressing UP and DOWN simultaneously.
“Locked” appears briefly on the message display.