User`s manual

3–18 Operating the Printer
Selecting a Font
NOTE: The procedure below selects a font in Digital emulation. The
procedure is the same for the Proprinter XL and Epson FX
emulations, but the font options differ. (Both procedures are charted
on the Configuration Diagram in Chapter 4, Printer Configuration.)
To select a font from the control panel:
1. If the printer is on–line, press the ON LINE switch to place it off–line.
2. Raise the printer cover.
3. Press UP and DOWN simultaneously to unlock the ENTER switch.
“Unlocked” displays momentarily. (If “Locked” displays, simply press
UP and DOWN again.)
4. Press DOWN. “Emulation/LG06 * ” displays.
5. Press DOWN. “LG06/Font” displays.
6. Press DOWN. “Font/Style” displays.
7. Press DOWN. “Style/[font]” displays.
8. Press NEXT or PREV to cycle through the font options. DP 10 6 is
default. The first number is characters per inch; the second number is
lines per inch. The font options are abbreviated on the display:
DP = Data Processing
CORESPON = Correspondence
COMPRESS = Compressed
HS = High Speed
OCR A = Optical Character Recognition, Set A
OCR B = Optical Character Recognition, Set B
9. When the desired font shows on the display, press ENTER. An asterisk
(*) appears on the display, indicating that this font will print.
10. Press CLEAR to return the printer to off–line status. The display reads
“Off–Line/Emulation.”
11. Press UP and DOWN simultaneously to lock the ENTER switch.
“Locked” displays momentarily.