User`s manual

11Index
Interfaces, 5–1
Maintenance, 6–2
Operation, 3–1
Reset, 7–125
Self–Tests, 6–6
Self–tests, 6–6
Specifications, B–1
Speed, B–6
Status Requests and Reports, 7–88
Test after installation, 2–14
Turning the printer off, 3–3
Turning the printer on, 3–3
Printer Deselect, Serial Matrix, 9–59
Printer Reset, 7–125
Printer Select, Epson FX, 9–59
Printer Status Reports, 7–89
Printing
Bold, 7–102
Enable printing of hex codes 00–F and
80–9F (Epson), 9–48
Italic, 7–3, 7–104
line printing explained, 1–5
speed, 1–6
Printing conventions in this manual, 1–3
Printing, Unidirectional, 8–52
Printouts
Configuration, 4–2
Hex code, 6–8
Privacy Messages, 7–119
Product Identification (DA), 7–87
Proportional spacing, Epson FX, 9–33
Protocol Selector, 7–109
PUM, 7–28
Q
Quiet Zone Setting (Bar Codes), A–4
R
R/S (Run/Stop) Switch, 3–8
Raster Attributes, Set, 7–114
Rates, printing and plotting, 1–6
Remove Downloaded Characters (Epson FX),
9–44
Repeat Introducer (!) and Sequence, 7–113
Report, Printer Status, 7–89
Request Forms Status (DECFMSR), 7–56
Request Logo Status (DECRLGS), 7–60
Requirements, printer, power, 2–2
Reset Condition, 7–131
Reset Terminal, Soft (DECSTR), 7–125
Reset to Initial State (RIS), 7–125
Reset, Emulation, Epson FX, 9–59
Reset, Printer, 7–125
Response, Printer, to DSR, 7–89
Reverse Index (RI), 7–73
RI, 7–73
Ribbon
Removing and installing, 3–20
Specifications, B–2
Right (and Left) Margins, Set, 7–70
RIS, 7–125
RS–232 serial interface, 5–9
Run/Stop (R/S) Switch, 3–8