User`s manual

10 Index
Parallel Interfaces
Centronics, 5–5
Dataproducts, 5–3
Parameter Separator, 7–117
Parameters, Numeric and Selective (Pn, Ps),
7–13
Parsing Requirements, 7–15
Partial Line Down (PLD) – Subscripting,
7–79
Partial Line Up (PLU) – Superscripting, 7–78
Perforation
Skip Over, Epson FX, 9–16
Skip Over Cancel, Epson FX, 9–16
PFS, 7–64
Pitch Select Mode (DECPSM), 7–26
PLD, 7–79
Plot
Bit image, 10–3
Speeds, B–6
Plot Density, Setting, 7–34
PLU, 7–78
Pn, Ps. See Parameters
Position Unit Mode (PUM), 7–28
Postnet, A–19
Power requirements, 2–2
Power switch, 3–3
Power–up Conditions, 7–132
Precedence, commands, 4–2
PREV Switch, 3–9
Print
Bold Reset code, 8–23
Condensed code, 8–20
Double Wide code, 8–24
Emphasized code, 8–27
Emphasized Reset code, 8–28
Expanded code, 8–24
Font, selecting from control panel, 3–18
Superscript/Subscript
Reset code, 8–50
Set code, 8–49
Print Area
Changing the, 7–63
Page, 7–62
Print Rates, B–6
Print Samples
Digital emulation, F–1
Proprinter emulation. See Chapter 8
Print Style, Near Letter Quality, 8–45
Printer
Command precedence, 4–2
Configuration, 4–1
Control codes
Digital emulation, 7–1
Proprinter emulation, 8–1
Default Values and States
Digital emulation, 7–130
Epson emulation, 9–4
Diagnostics, 6–1
Dimensions, B–3
Emulations
Digital, 7–2
Epson FX, 9–3
Proprinter, 8–2
Emulations, changing, 4–7
Error Codes (LN03 PLUS), 7–91
Fault messages, 6–9
features, 1–3
Graphics, 10–1
IBM emulation, 8–1
installation, 2–1
Interface configuration with the VMS
operating system, D–1