User`s manual

D–2 Interface Configuration with VMS
Serial Interface
When using the serial interface with the VMS operating system, configure
the terminal characteristics with the SET TERM command, as shown below:
Terminal: _TXA3: Device_Type: Unknown Owner: SYMBIONT_0001
Username: SYSTEM
Input: 9600* LFfill: 0 Width: 132 Parity: None
Output: 9600* CRfill: 0 Page: 66
Terminal Characteristics:
Interactive
No Hostsync
No Wrap
No Broadcast
No Modem
No Brdcstambx
Line Editing
No Secure server
No SIXEL Graphics
No ANSI_CRT
No Edit_mode
Echo
TTsync
Scope
No Readsync
No Local_echo
No DMA
Overstrike editing
No Disconnect
No Soft Characters
No Regis
No DEC_CRT
Type_ahead
Lowercase
No Remote
Form
No Autobaud
No Altypeahd
No Fallback
No Pasthru
No Printer Port
No Block mode
No DEC_CRT
No Escape
Tab
No Eightbit
Fulldup
No Hangup
Set_speed
No Dialup
No Syspassword
Numeric Keypad
No Advanced_video
Device spooled to _DUAL:
* Match baud rate to printer settings.