User`s manual

3–12 Operating the Printer
Loading Paper After a “Paper Out” Message
NOTE: This procedure allows you to load paper without having to reset the
top–of–form.
1. Raise the printer cover.
2. Raise the forms thickness lever all the way. (See Figure 3–4.)
3. Press the CLEAR switch to silence the alarm.
4. Open the floor cabinet front door and align the paper supply with the
label on the floor of the cabinet.
5. Without removing the existing paper, feed the new paper up through the
paper slot until it appears behind and above the ribbon mask, but in
front of the existing paper. You may have to gently press the existing
paper back.
6. Line up the edge of the new paper with the perforation of the existing
paper.
7. Open the right tractor gate by swinging it out. Lay the new paper over
the existing paper on the tractor sprockets and close the right tractor
gate.
8. Open the left tractor gate by swinging it out. Lay the new paper over the
existing paper on the tractor sprockets and close the left tractor gate.
9. Close the forms thickness lever and the front door.
10. Press the ON LINE switch to place the printer on–line. Resume printing.