User`s manual

3–9Operating the Printer
• With “Off–line/Print Config” showing on the display, press R/S to
print out the current configuration. (Refer to Chapter 4, Printer
Configuration.)
SET TOF (Top–Of–Form) Switch
The SET TOF switch functions only when the printer is off–line. It moves
the paper backwards from the top–of–form notch to the print station. (See
page 3–16.)
This switch is not active during a fault condition.
ENTER Switch
The ENTER switch loads the value shown on the message display into
printer RAM and indicates this by displaying an asterisk (*) to the right of
the value. The previous value is replaced by the displayed value.
The ENTER switch must be unlocked before making configuration changes.
Simultaneously press UP and DOWN when the display shows “Off–line
Emulation” to lock and unlock the ENTER switch. (This sequence protects
against accidental reconfiguration.) No other switches are affected by this
action. The display reads either “Unlocked” or “Locked” for one second,
then returns to “Off–line Emulation.”
Resetting the printer or turning the power off and on automatically locks the
ENTER switch.
UP, DOWN, NEXT, and PREV Switches
Simultaneously press UP and DOWN to lock and unlock the ENTER switch.
The UP, DOWN, NEXT, and PREV switches also display configuration
parameter main menus, submenus, and diagnostic tests. A value shown on
the display with an asterisk (*) is the currently active parameter value
retained in printer memory. (Refer to Chapter 4, Printer Configuration.)
NOTE: When the printer is off–line, configuration menus and parameter
values may be viewed at any time, but they may only be changed by
unlocking and using the ENTER switch. The ENTER switch loads a