User`s manual

3–8 Operating the Printer
FF (Form Feed) Switch
This switch is active only when the printer is off–line. Press FF to advance
the paper to the top–of–form of the next page. Any unprinted data remaining
in the print buffer will print before the paper moves.
This switch is not active during a fault condition.
LF (Line Feed) Switch
This switch is active only when the printer is off–line. Press this switch to
advance the paper to the top of the next print line. Any unprinted data
remaining in the buffer will print before paper motion occurs.
This switch is not active during a fault condition.
VIEW Switch
This switch is active only when the printer is off–line. Press this switch to
advance the paper for viewing through the window on the printer cover.
Press VIEW again to move the paper back into the print position.
CLEAR Switch
The CLEAR switch operates only when the printer is off–line. If a fault
condition occurs, an error message appears on the display and the status
lamps flash alternately. Correct the problem, then press the CLEAR switch to
tell the printer that a fault condition has been corrected. When all faults are
corrected, the display indicates the printer is off–line. If CLEAR is pressed
when a configuration parameter value is displayed, the printer returns to
off–line status (“Off–line/Emulation”).
R/S (Run/Stop) Switch
R/S performs the following functions:
• With a diagnostic test showing on the display, press R/S to start the
test. Press R/S again to stop the test.
• Simultaneously press the Clear and R/S switches to reset the printer
to the last saved configuration.