User`s manual
9–59Epson FX Emulation
Initialize Printer
ASCII Code ESC @
HEX Code 1B 40
Purpose Resets all print–related parameters to values previously saved.
Comment Resets the previously saved values and the print buffer is cleared of
printable data on the line preceding the command. Current position is
set as top–of–form.
Font, international language selection, form length, skip–over
perforation, and character pitch are reset to previously saved values.
Other values are returned to default values. Character–by–character
and line–by–line attributes are canceled. All channels of the vertical
format unit are cleared. This command resets the horizontal tabs to
every eighth character column. Interface parameters and printer
protocol selection are not affected.
Printer Select, Remote
ASCII Code DC1
HEX Code 11
Purpose Places printer in the selected state.
Comment This control code allows the printer to receive and print data from
the host if it was deselected by DC3. If the printer was not deselected
by DC3, this code is ignored.
Printer Deselect, Remote
ASCII Code DC3
HEX Code 13
Purpose Places printer in the deselected state.
Comment When the printer receives this command it stops receiving and
printing data until a DC1 (Printer Select) command is received.