User`s manual

9–25Epson FX Emulation
Line Spacing n/72 Inch
ASCII Code ESC A n
HEX Code 1B 41 n
Purpose Sets a line spacing of n/72 inch for subsequent line feeds.
where n = 0 to 85 (all other values are ignored)
Comment When this control sequence is received, all subsequent line feeds are
n/72–inch until a new line spacing is selected or power is reset. This
setting overrides line spacing set at the control panel.
Small values of n may result in overlapping lines. Overlapping lines
may also occur if print attributes such as Elongated (Double High),
Superscript, or Subscript characters are used on the same line. If
lines overlap, printing speed is reduced. Any values set by ESC 3
(line spacing n/216 inch) are replaced.
Example The following example illustrates 20/72–inch line spacing.