User`s manual

2–13Installation
Connect the Interface and Power Cables
NOTE:
Connector
Cover
Refer to Chapter 5,
Interfaces , for
descriptions of the connectors and the pin
assignments.
Centronics
Connector*
Dataproducts
Connector*
EIA–232 Serial
Connector*
Power Switch
AC Power Connector
LG06 LG12
* Suggested DEC cables:
Dataproducts parallel
Centronics parallel
Serial
BC27A–30
BC27L–30
BC19M–10
BC22D–25
Figure 2–10. Cable Connections
1. Make sure the voltage source at the printer site conforms to the
requirements specified on page 2–2.
2. Verify that the printer power switch is set to off.
3. Connect the power cord to the printer’s AC power connector and to the
AC line receptacle. (See Figure 2–10.)
4. Connect the interface cable (not supplied with the printer) to the
appropriate printer interface connector and to the host computer.
5. Install the supplied connector covers on the unused interface connectors.
6. Refer to Chapter 4 to configure the printer interface.