User`s manual

9–15Epson FX Emulation
Set Page Length in Inches
ASCII Code ESC C 0 n
HEX Code 1B 43 30 n
Purpose Sets page length to n inches.
where n = whole numbers (hex values) from 1 to 24 to specify the number
of inches on a page.
Comment Upon receipt of this code, the current line becomes the first line of
the form, and the form length set becomes the current forms length.
Vertical tab positions set below the bottom of the form are ignored.
Forms length is defined in inches; therefore, subsequent line spacing
changes do not affect the result of this command.
Values of n greater than 24 are ignored.
When forms length is set by an ESC C sequence, the skip–over
perforation set by ESC N is cancelled.
This control code overrides forms length set at the control panel.