User`s manual

9–3Epson FX Emulation
Selecting Epson Emulation
You select the Epson emulation from the control panel:
1. If the printer is on–line, press the ON LINE switch to place it in the
off–line state. “Off–Line Emulation” appears on the message display.
2. Open the printer cover.
3. On the control panel, press UP and DOWN simultaneously to unlock the
ENTER switch. “Unlocked” appears briefly on the message display. (If
“Locked” appears, simply press UP and DOWN again.)
4. Press DOWN to enter the emulation menu. The current emulation
displays. If the display reads “Emulation Epson FX * ” go to step 8.
5. Press NEXT or PREV until “Emulation Epson FX” displays.
6. Press ENTER. An asterisk ( * ) appears after the display message.
(“Emulation Epson FX * ” displays.) This indicates that the printer has
set all configuration values associated with Epson emulation mode. The
values are those previously saved when Epson emulation was selected.
If no values were altered, the factory default values are loaded. (See
Table 9–1.)
7. If you want to change the default values of the Epson emulation, refer to
the configuration diagram and procedures in Chapter 4. When the
configuration options are set to your satisfaction, go to step 8.
8. Press CLEAR to return to “Off–Line Emulation.”
9. Press UP and DOWN simultaneously to lock the ENTER switch.
“Locked” appears briefly on the message display.
10. Close the printer cover.
11. Press the ON LINE switch to place the printer on–line to the host
computer.