User`s manual

8–43IBM Proprinter Emulation
Line Spacing n/72 Inch (Storage)
ASCII Code ESC A n
Hex Code 1B 41 n
Dec Code 27 65 n
Purpose Stores a line spacing of n/72–inch increments.
Discussion Line spacing can be set in any increment from 1 to 255, inclusive. All
other n values cause the command sequence to be ignored up to the point
of the detected error. Subsequent symbols are then interpreted. To
execute this setting, refer to “Line Spacing n/72 Inch (Execution),” page
8–42.
Line spacing can occur at any place in the datastream and is acted upon
immediately. All control codes that define vertical distance expressed in
inches are stored internally in units of paper drive steps.
Example The following example illustrates 20/72–inch line spacing.