User`s manual

8–26 IBM Proprinter Emulation
Double Wide Print (Cancel)
ASCII Code DC4 ESC DC4
Hex Code 14 1B 14
Dec Code 20 27 20
Purpose Cancels double wide print, if it was set by command SO.
Discussion The DC4 code cancels Double Wide Print command SO. If Double Wide
Print is not enabled, the DC4 code is ignored. A DC4 code can occur at
any place in the datastream and is acted upon immediately.
When you cancel double wide print, the characters per inch revert to the
following:
• If the Proprinter emulation is printing at 5 cpi, cancelling double wide
print causes the print to revert to 10 cpi.
• If the Proprinter emulation is printing at 6 cpi, cancelling double wide
print causes the print to revert to 12 cpi.
• If the Proprinter emulation is printing at 8.55 cpi, cancelling double
wide print causes the print to revert to 17.1 cpi.