User`s manual

7–131Digital Emulation
Upon receipt of a reset, the printer uses the default values in Table 7–23.
Table 7–23. Reset Condition
Selectable Parameter Control Function Factory Set Condition
Printing Status ––––– On–line (Ready)
Horizontal Pitch DECSHORP 10 characters per inch
Vertical Pitch DECVERP 6 lines per inch
Font SGR Data Processing
Forms Length DECSLPP 66 lines (11 inches)
Active Position ––––– Column 1 on the current active line
Top Margin ––––– Line 1
Bottom Margin ––––– Line 66
Left Margin ––––– Column 1
Right Margin ––––– Column 136
Underlining SGR Disabled
Bolding SGR Disabled
Italics SGR Disabled
Double Underline SGR Disabled
Overline SGR Disabled
Expansion GSM No character expansion
GL Character Set ––––– US ASCII
GR Character Set ––––– Digital Supplemental
G0 Character Set ––––– US ASCII or the last NRC if selected
G1 Character Set ––––– VT100 Graphic Character Set
G2 Character Set ––––– Digital Supplemental
G3 Character Set ––––– US ASCII
Autowrap DECAWM Disabled
Line Feed/New Line Mode LNM Reset
Horizontal Tabs ––––– Stop at every 8 columns (9, 17...137)
Unsolicited Reports DSR Disabled
Super/Subscripts ––––– Disabled
Carriage Return/New Line
Mode
DECCRNLM Reset
Vertical Tabs ––––– Stop at every line (1–66)
Note: The “All Interface Settings” and “National Replacement Character Set” remain as
previously selected via escape sequences or the control panel.