User`s manual

7–23Digital Emulation
Line Feed/New Line Mode (LNM)
Set (Enable) Reset (Disable)
ASCII Code ESC [ 2 0 h ESC [ 2 0 l
Hex Code 1B 5B 32 30 68 1B 5B 32 30 6C
Dec Code 27 91 50 48 104 27 91 50 48 108
Purpose Defines the paper position according to how the line feed features are
enabled.
Discussion Advance the paper up one line by pressing the line feed key once. A
half–second pause ensues, then the paper will feed one line. To feed
paper continuously, hold down the line feed key. After the half–second
pause, the paper feeds up one line in 3 hertz intervals.
To enable further line feed features, (i.e., microstepping), raise the printer
cover and locate the control panel on the left side. Four keys—UP, NEXT,
DOWN, and PREV—control additional line feed capabilities:
To move paper up 1/600 inch, depress the LINE FEED key and the NEXT
key together. After a half–second interval, paper feeds continuously at 3
hertz intervals. For continuous forward paper feed at 1/600 inch, hold down
the LINE FEED key and the NEXT key, and paper will feed at 3 Hertz
intervals after a half–second pause.
Whether Line Feed/New Line mode is enabled or disabled, a Carriage Return
<CR> control code is interpreted according to the DECCRNLM mode in use.
(See “Carriage Return/New Line Mode,” page 7–24.)
LNM remains as selected from the last power–on session. Factory default is
LNM reset.