User`s manual

7–18 Digital Emulation
Control Code Index and Descriptions
The Digital emulation mode control codes listed below are grouped by
related functions.
Control code sequences in this manual are shown in 7–bit form. They can be
either 7–bit or 8–bit form, depending on your requirements. Code conversion
instructions are on page 7–11.
For commands that turn features on and off (set/reset, enable/disable), the
page number for the enabling command is listed. The disabling command is
on the same page.
IMPORTANT
In the index below SP represents the ASCII space character (decimal 32,
20
H
). (A two–digit number followed by a subscripted capital H is a
hexadecimal number. Numbers without subscripts are decimal
numbers.)
Function Code Page
Set/Reset Mode ESC[Psh 7–22
Line Feed/New Line Mode (LNM) ESC[20h 7–23
Carriage Return/New Line Mode (DECCRNLM) ESC[?40h 7–24
Autowrap Mode (DECAWM) ESC[?7h 7–25
Pitch Select Mode (DECPSM) ESC[?29h 7–26
Set Page Orientation (DECSPO) ESC[Ps&z 7–27
Position Unit Mode (PUM) ESC[1lh 7–28
Force Plot Mode (DECFPM) ESC[?70h 7–30
Select Size Unit (SSU) ESC[PsSPI 7–31
Graphic Size Selection (GSS) ESC[PnSPC 7–32
Graphic Size Modification (GSM)
ESC[Pn1;Pn2SPB 7–33