User`s manual

7–9Digital Emulation
Table 7–2. Additional Control Codes
Index
Next Line
Horizontal Tab
Vertical Tab Set
Partial Line Down
Partial Line Up
Reverse Index
NameMnemonic
Column/Row
Function
IND
NEL
HTS
VTS
PLD
PLU
RI
8/4
8/5
8/8
8/10
8/11
8/12
8/13
Set
Single Shift 2
Single Shift 3
Device Control
String
Control String
Introducer
String Terminator
SS2
SS3
DCS
CSI
ST
8/14
8/15
9/0
9/11
9/12
IND moves the active position down to the same position on
the next line. If the new position is below the bottom
margin, the active position moves to the top of the next page.
NEL moves the active position to the left margin on the next
line. If the new position is below the bottom margin, the
active position moves to the top of the nex page.
HTS sets a horizontal tab at the active column.
VTS sets a vertical tab at the active line.
PLD moves the active position down one–half line. The
distance moved is specified as a parameter of the font, not by
vertical spacing escape sequences.
PLD moves the active position up one–half line. The
distance moved is specified as a parameter of the font, not by
vertical spacing escape sequences.
RI moves the active line position up to the same position on
the preceding line.
SS2 moves character set G2 into Gl, to print one character.
SS3 moves character set G3 into Gl, to print one character.
DCS introduces a device control string.
CSI introduces a sequence of one or more bytes that define a
control function.
ST indicates the end of a device control string (DCS).
9/DH–9/FH
<OSC>, <PM>, <APC>: See “note”
NOTE: The LG06 and LG12 recognize the start of this control string but ignore all data that follow
until this sequence is either aborted or terminated by an <ST> sequence.