Specifications

5–18 Replacement Procedures
Circuit Breaker (Figure 5–6 )
Removal
1. Prepare the printer for maintenance (page 5–3).
2. Open the rear cabinet door.
3. Remove six screws (1) and move the fan duct (2) aside.
4. Tag and disconnect the four circuit breaker electrical leads (3).
5. Press in on the spring clips (4) and push the circuit breaker (5) out of the
mounting plate (6).
Installation
1. Press the circuit breaker (5) into the mounting plate (6) until the spring
clips (4) snap into place.
CAUTION
Make sure the four leads are connected as shown in Figure 5–6 .
2. Connect the four circuit breaker electrical leads (3) as shown in
Figure 5–6 .
3. Move the fan duct (2) back into position and install the six screws (1).
4. Return the printer to normal operation (page 5–80).