Specifications

5–16 Replacement Procedures
Installation
1. Feed the multi I/O ribbon cable from the lower cabinet up into the
opening at the right rear of the card cage. Route the ribbon cable
outboard of the right gas spring assembly (the strut that holds the printer
cover open).
2. Install four screws (7) securing the multi I/O cable assembly mounting
plate (8).
3. Connect the multi I/O ribbon cable connector (5) to connector J1 (6) on
the common controller PCBA and close the latches (4).
4. Latch the multi I/O ribbon cable into the cable restraints (3) located on
the upper rear and upper right cabinet walls.
5. Engage the multi I/O ribbon cable in the holders on the rear wall of the
card cage.
6. Move the fan duct (2) into position and install the six screws (1).
7. Close the rear cabinet door.
8. Install the paper guide assembly (page 5–42).
9. Return the printer to normal operation (page 5–80).