Specifications

5–14 Replacement Procedures
Cable Assembly, Multi I/O (Figure 5–5 )
Removal
1. Prepare the printer for maintenance (page 5–3).
2. Open the printer cover.
3. Remove the paper guide assembly (page 5–42).
4. Open the rear cabinet door.
5. Remove six screws (1) and move the fan duct (2) aside.
6. Open the ribbon cable restraints (3) on the upper rear and upper right
walls of the cabinet.
7. Open the latches (4) and disconnect the multi I/O ribbon cable connector
(5) from connector J1 (6) on the common controller PCBA.
8. Release the multi I/O ribbon cable from the holders on the rear wall of
the card cage.
9. Feed the multi I/O ribbon cable through the card cage and down into the
cabinet.
10. Remove four screws (7) securing the multi I/O cable assembly mounting
plate (8).
11. Remove the multi I/O cable assembly (9).