Specifications
5–10 Replacement Procedures
Cable Assembly, Intermediate (Figure 5–4 )
Removal
1. Prepare the printer for maintenance (page 5–3).
2. Open the printer cover.
3. Remove the paper guide assembly (page 5–42).
4. Remove the common controller PCBA (page 5–46).
5. Remove the mechanism driver PCBA (page 5–48).
6. Remove screws (1) securing the main wire harness connector (2) to the
bottom of the card cage. Move the main harness connector to one side.
7. Remove screws (3) securing the intermediate cable assembly connector
P1 (4) to the bottom of the card cage.
8. Disconnect connector P1(P) (5) from platen interlock switch assembly
(6).
9. Disconnect connector PMD (7) from paper detector switch assembly
connector PMD(J) (8).
10. Remove the cover open switch assembly (9) and disconnect connectors
CO+ and CO– (10 and 11).
11. Note the location of cable runs and restraints, cut tie wraps, and remove
the intermediate cable assembly (12) through the card cage.