Specifications

A–3Printer Configuration
Configuration Procedure
Use the following procedure to configure the printer from the control panel:
1. Obtain a configuration printout (page A–2).
2. Determine the parameter values that must be changed to meet your
requirements.
3. Take the printer off–line by pressing the ON LINE switch.
4. Open the printer cover.
NOTE: You must unlock the ENTER switch to change a configuration
value. If you leave the ENTER switch locked you can examine — but
not change — the current configuration.
5. Press UP and DOWN simultaneously to unlock the ENTER switch.
“Unlocked” appears briefly on the message display.
6. Locate the desired menu by pressing DOWN and then NEXT or PREV
until the menu name appears on the display. Use the Configuration
Diagram (page A–7) as your “road map.”
7. Locate the desired value in a menu by pressing DOWN, then pressing
NEXT or PREV until the desired value appears on the display.
8. Press ENTER when the desired value is showing on the message
display.
9. Press UP, then NEXT or PREV to move to the next desired menu.
Repeat steps 7 and 8.
10. After you have made all required parameter changes, press CLEAR. The
display goes to “Off–Line/Emulation.” Press NEXT until
“Off–Line/Save Config” displays. Press ENTER. This saves the
parameter values as the power–up default values.
11. Lock the ENTER switch by pressing UP and DOWN simultaneously.
“Locked” appears briefly on the message display.
12. Close the printer cover. Place the printer on–line by pressing ON LINE.
Your selected values are now active.