Specifications

5–76 Replacement Procedures
Switch Assembly, Paper Detector (Figure 5–34 )
Removal
1. Prepare the printer for maintenance (page 5–3).
2. Remove the paper guide assembly (page 5–42).
3. Remove four screws (1) and the barrier shield (2).
4. Remove the shuttle frame assembly (page 5–66).
5. Remove the paper ironer (page 5–44).
6. Loosen the screws (3) securing the paper detector switch assembly (4).
7. Disconnect the paper detector switch cable connector (5) from the
intermediate cable assembly connector PMD.
8. Cut the tie wraps securing the switch assembly cable to the front of the
card cage and remove the paper detector switch assembly (4).
Installation
1. Position the paper detector switch assembly (4) and install the screw (3)
securing it to the printer base.
2. Connect the paper detector switch cable connector (5) to the
intermediate cable assembly connector PMD.
3. Install tie wraps securing the switch assembly cable to the front of the
card cage.
4. Install the paper ironer (page 5–44).
5. Install the shuttle frame assembly (page 5–66).
6. Install the barrier shield (2) and four screws (1).
7. Install the paper guide assembly (page 5–42).
8. Return the printer to normal operation (page 5–80).