Specifications

5–70 Replacement Procedures
Spring Assembly, Gas (Figure 5–31 )
Removal
1. Prepare the printer for maintenance (page 5–3).
2. Open the printer cover (1).
3. Open the floor cabinet rear door.
4. Remove two nuts (2) and washers (3).
5. Remove the gas spring assembly (4).
Installation
1. Position the gas spring assembly (4) on the upper and lower brackets (5
and 6).
2. Install two nuts (2) and washers (3).
3. Close the printer cover (1): make sure the cover closes all the way. If
necessary, adjust the position of the stud in the lower bracket to achieve
smooth and complete closure.
4. Return the printer to normal operation (page 5–80).