Specifications

5–64 Replacement Procedures
Shaft, Support (Figure 5–29 )
Removal
1. Prepare the printer for maintenance (page 5–3).
2. Open the printer cover.
3. Unlock the tractors (1) and slide them to the far left.
4. Remove the E ring (2).
5. Slide the support shaft assembly — consisting of the support shaft (3), two
spring washers (4), bushing (5), horizontal adjustment knob (6), washer
(7) and screw (8) — to the left, out of the tractors (1) and the left side plate
(9).
Installation
1. Slide the support shaft assembly — consisting of the support shaft (3), two
spring washers (4), bushing (5), horizontal adjustment knob (6), washer
(7), and screw (8) — into the left side plate (9).
2. Slide the tractors (1) onto the support shaft (3).
3. Slide the support shaft assembly through the right side plate (10).
4. Install the E ring (2).
5. Return the printer to normal operation (page 5–80).