Specifications

5–44 Replacement Procedures
Paper Ironer (Figure 5–19 )
Removal
1. Remove the shuttle frame assembly (page 5–66).
2. Move the forms thickness lever (1) to the open position.
WARNING
Over time, the upper edge of the paper ironer can become sharp. To
avoid cutting yourself, grasp the paper ironer on the sides.
3. Push back at the ends of the paper ironer (2) to disengage the tabs, then
lift it up and out.
Installation
WARNING
Over time, the upper edge of the paper ironer can become sharp. To
avoid cutting yourself, grasp the paper ironer on the sides.
1. Position the paper ironer (2) so that the lip on the upper edge faces the
front of the printer.
2. Push the paper ironer (2) down into the slots until the tabs engage.
3. Install the shuttle frame assembly (page 5–66).
4. Return the printer to normal operation (page 5–80).