Specifications

5–33Replacement Procedures
Hammer Spring Replacement Kit: P/N 29–29281–01
Hammer
Fret 1
Hammer
Fret 7
Hammer Bank
See
See NOTE.
Preparation – Frets 1 and 7 only
NOTE.
Bend this hammer if
replacing fret 7.
NOTE:
If you replace fret 1 or 7, bend the end
hammer down BEFORE removing it from
the box, as shown below. Do this ONLY
for frets 1 and 7.
Bend this hammer if
replacing fret 1.
Use these screws
to install new fret.
Removal – Any Fret
Discard
old screws.
Installation – Any Fret
1.2. 3.
8 in–lbs
Tightening Sequence
(Torque to 8 in–lbs)
Use new
screws.
Bend hammer down
until it touches the
mounting base in the
box.
Left end
Right end
Figure 5–13 . Hammer Spring Assembly Removal/Installation