Installation guide

Do you really want to reset ALL partitions? (Y/<N>)
Type Y to perform the reset.
4. After the reset is completed and if auto_action is set to BOOT, the
console firmware will automatically reinitialize all partitions. Boot the
operating system in each partition, using the following commands:
P00>>>boot
P##>>>boot
Otherwise, enter the following commands (where N is the number of
partitions):
P00>>>set lp_count N
P00>>>init
P00>>>lpinit
P00>>>boot
and for each secondary partition enter the following:
P##>>>boot
If these recovery procedures fail to restore full system operation for all
partitions, reset the system manually by momentarily moving the
OFF/ENABLE switch to the RESET position, then releasing it. After the
reset is completed repeat the recovery procedure. If the failure persists,
contact your Compaq customer service representative.
E.4.10 Logical Partitioning Error Messages
If an error condition occurs (such as an invalid partition configuration) a
message is displayed on the partition’s console terminal. After displaying
the error message, the primary processor for the current partition will halt
and return to the console prompt. To recover from any of these errors,
correct the logical partitioning console EVs and reboot the partition.
The following error messages may be displayed:
LP_ERROR: invalid partition count (lp_count = #, max nodes
=#)
The lp_count console EV is set incorrectly. The value is less than
zero or exceeds the maximum number of partitions supported for the
AlphaServer GS140.
LP_ERROR: no CPUs for partition (check lp_cpu_mask)
The value of lp_cpu_mask# (# represents the current partition
number) is set incorrectly. There are no processors allocated to this
partition.
E–32 Administering Specific Hardware