Installation guide

P00>>>set lp_count 0
P00>>>set lp_cpu_mask0 f
P00>>>set lp_cpu_mask1 f0
P00>>>set lp_io_mask0 100
P00>>>set lp_io_mask1 80
P00>>>set lp_mem_mode isolate
E.4.3.7 Disabling Automatic Boot Reset
The boot_reset console EV must be set to OFF. This is required so
booting a partition does not interfere with the operation of other
(previously booted) partitions. If boot_reset is set ON, then a system wide
reset is done when the boot command (P00>>>boot) is executed. This reset
will immediately terminate operation of all partitions.
Execute the following command to disable boot_reset:
P00>>>set boot_reset off
E.4.3.8 Set Memory Interleave Mode
The interleave console EV must be set to none. Use the following
commands to set the memory interleave mode:
P00>>>set interleave none
P00>>>init
and proceed to the next section.
E.4.3.9 Set the Operating System Type to UNIX
Set the os_type console EV to UNIX as follows:
P00>>>set os_type UNIX
E.4.3.10 Set the auto_action Console Environment Variable
To halt the processor after a POWER-ON or RESET (using the reset
switch), use the following command:
P00>>>set auto_action halt
To automatically boot the operating system after a POWER-ON or RESET,
use the following command:
P00>>>set auto_action boot
E.4.4 Initializing Partitions
Before installing Tru64 UNIX to partitions you need to initialize the
partitions. This operation assigns hardware resources (CPU, IOP, and MEM
E–20 Administering Specific Hardware