Installation guide

2. After a short delay (about 15 seconds) configuration information
(similar to the following example) will display on the primary console
screen:
FEDCBA9876543210NODE#
AAM.MPPPPTYP
o o + . + ++ ++ ++ ++ ST1
. . . . . EE EE EE EB BPD
o o + . + ++ ++ ++ ++ ST2
. . . . . EE EE EE EB BPD
+ + + . + ++ ++ ++ ++ ST3
. . . . . EE EE EE EB BPD
.+++.+++C0PCI+
......+..+..++ C1XMI+
................C4
+.++....+..+C5PCI+
................C6
+.++.+++...+C7PCI+
...+.... EISA +
..A1.A0....ILV
..1GB.1GB....2GB
Compaq AlphaServer GS140 8-6/525, Console V5.4 15-MAR-99 10:07:33
SROM V1.1, OpenVMS PALcode V1.48-3, Tru64 UNIX PALcode V1.45-3
System Serial = , OS = UNIX, 12:58:49 March 15, 1999
Configuring I/O adapters...
isp0, slot 0, bus 0, hose0
isp1, slot 1, bus 0, hose0
tulip0, slot 2, bus 0, hose0
isp2, slot 4, bus 0, hose0
isp3, slot 5, bus 0, hose0
tulip1, slot 6, bus 0, hose0
demna0, slot 1, bus 0, xmi0
kzmsa0, slot 2, bus 0, xmi0
kzmsa2, slot 5, bus 0, xmi0
kzpsa0, slot 3, bus 0, hose5
tulip2, slot 8, bus 0, hose5
tulip3, slot 9, bus 0, hose5
pfi0, slot 11, bus 0, hose5
tulip4, slot 12, bus 0, hose7
floppy0, slot 0, bus 1, hose7
kzpsa1, slot 4, bus 0, hose7
tulip5, slot 4, bus 2, hose7
tulip6, slot 5, bus 2, hose7
tulip7, slot 6, bus 2, hose7
tulip8, slot 7, bus 2, hose7
pfi1, slot 6, bus 0, hose7
pfi2, slot 8, bus 0, hose7
kzpsa2, slot 9, bus 0, hose7
P00>>>
3. The line ending with NODE # indicates the slot number (referred to
later in the configuration process). Your system will have up to nine
slots, each of which is labelled with its slot number. The next line
(ending with TYP) indicates the type of module in each slot. Record the
type of module in each slot:
P = CPU (dual processor CPU module)
M = MEM (memory module)
Administering Specific Hardware E–15