Installation guide

The filename variable specifies the event-log file to use. You must specify
the full pathname for the file, for example:
# /usr/sbin/uerf -f /var/adm/binary.old
You cannot specify the −n option with the −f option.
D.1.8 Generating Reports for Hosts
Use the uerf command with the −H option to select events for the
specified host system. Use this option if events from remote systems are
being forwarded to your local system. The uerf −H command has the
following syntax:
uerf -H hostname
D.1.9 Selecting Events by Record Code
Use the uerf command with the −r option to select events with the
specified record codes. The −r option offers an alternate way to report
specific events, such as disk and tape events. The uerf −r command has
the following syntax:
uerf -r record
...
You can specify the following record variables:
Record code Hardware-Detected Events
100 CPU machine checks and exceptions
101 Memory errors (soft and hard)
102 Disk errors
103 Tape errors
104 Device controller errors
105 Adapter errors
106 Bus errors
107 Stray interrupts
108 Console events
109 Stack dump
199 CAM (SCSI) events
Record code Software-Detected Events
201 ci ppd events
202 scs events
Using the uerf Event Logger D–7