Installation guide

0x39c39c39...
scu> scan media lba 200 limit 25k align ’lp-1’
Scanning 50 blocks on /dev/rrz10c (RX23) with pattern
0x39c39c39...
scu> scan media starting 0 bs 32k records 10
Scanning 640 blocks on /dev/rrz10c (RX23) with pattern
0x39c39c39...
Scanning blocks [ 0 through 63 ]...
Scanning blocks [ 64 through 127 ]...
Scanning blocks [ 128 through 191 ]...
Scanning blocks [ 192 through 255 ]...
Scanning blocks [ 256 through 319 ]...
Scanning blocks [ 320 through 383 ]...
Scanning blocks [ 384 through 447 ]...
Scanning blocks [ 448 through 511 ]...
Scanning blocks [ 512 through 575 ]...
Scanning blocks [ 576 through 639 ]...
set
The set command sets parameters for a device or sets environment
parameters for the scu program. See the on-line help text that is part
of the scu utility for an explanation of each parameter.
{ audio keywords }
{ cam debug hex-flags }
{ debug { on | off } }
{ default parameter }
set { device device-type }
{ dump { on | off } }
{ dump-limit value }
{ log file-name-path }
{ nexus nexus-information }
{ pages [ mode-page [ pcf page-control-field ]}
{ pager paging-filter }
{ paging { on | off } }
{ recovery { on | off } }
{ tape keywords ... }
{ verbose { on | off } }
{ watch { on | off } }
show
You use this command to display parameters for a device or the
program. See the scu online help for more information.
{ audio keywords }
{ capacity }
{ defects }
{ device }
show { edt }
{ memory }
{ mode-pages }
{ nexus }
{ pages }
{ path-inquiry }
SCSI/CAM Utility Program B–5