Installation guide

B.5 Device and Bus Maintenance Commands ........................ B–9
C Support of the CI and HSC Hardware
C.1 Hardware Setup, Restrictions, and Revision Levels ............ C–1
C.2 Software Installation and Restrictions ............................ C–2
C.3 Configuration File Entries .......................................... C–2
C.4 Booting an HSC Controller or HSC Disk ......................... C–2
C.5 Sharing Disk and Tape Units Among Several Hosts ........... C–3
D Using the uerf Event Logger
D.1 Specifying the Report Source ....................................... D–4
D.1.1 Selecting the Event Class ...................................... D–4
D.1.2 Selecting Disk Events ........................................... D–4
D.1.3 Selecting Mainframe Events ................................... D–5
D.1.4 Selecting Events As They Occur .............................. D–5
D.1.5 Selecting Operating System Events .......................... D–5
D.1.6 Selecting Tape Events ........................................... D–6
D.1.7 Generating Reports from Files ................................ D–6
D.1.8 Generating Reports for Hosts .................................. D–7
D.1.9 Selecting Events by Record Code ............................. D–7
D.2 Restricting Events .................................................... D–8
D.2.1 Specifying Sequence Numbers ................................. D–8
D.2.2 Specifying a Time Range ....................................... D–9
D.2.3 Specifying Unit Numbers ....................................... D–10
D.2.4 Excluding Reported Events .................................... D–10
D.3 Controlling the Report Output ..................................... D–10
D.3.1 Generating Summary Reports ................................. D–10
D.3.2 Specifying the Type of Output ................................. D–10
D.3.3 Generating Reports in Reverse Chronological Order ...... D–11
D.3.4 Displaying Hexadecimal Output .............................. D–11
E Administering Specific Hardware
E.1 Introduction ............................................................ E–1
E.2 PCMCIA Support ..................................................... E–1
E.2.1 Restrictions .......................................................
E–1
E.2.2 Configuring a PCMCIA Adapter Board from the Console E–2
E.2.2.1 Configuring a PCMCIA on an ISA Bus System ........ E–3
E.2.2.2 Configuring a PCMCIA on an EISA Bus System ...... E–4
E.2.3 Configuring and Using a PCMCIA Modem PC Card ...... E–4
E.2.4 Creating a Device Special File for the Modem Card ....... E–5
E.2.5 The /etc/remote File .............................................
E–6
Contents xv