User guide

Table A–1 (Cont.) Set-up Features and Values - Common Features for
both Dec and IBM protocols
Number Feature Value
Generic 10 Error Beep
2
1 One Beep *
2 Three Beeps
3 Continuous
4 Off
Generic 11 Typestyle
1 Internal *
2 Cartridge
3
Generic 12 Input Buffer Size
4
1 8K*
2 32 K - No DLL Capability
Generic 13 Disconnect on Fault
5
1 No action *
2 Drop DTR
2
This feature selects the beep signal when there is a "Paper out" or "Paper jam" condition. The
printer always sounds one beep when BEL control code is received.
3
Value number 2 may be selected even if no cartridge is installed. If no cartridge is installed,
typestyle is internal, but this value is not changed in NVM.
4
Input Buffer Size:
If standard buffer size is selected, the resident DLL capability is limited to 32 K Bytes.
If the input buffer size is extended, there is no down loaded character (DLL) capability.
5
On any condition that makes the Fault indicator On or blinking, if this feature is set to 2, the
DTR serial signal is dropped until the fault is corrected.
Set-up A–5