User guide

A
Set-up
A.1 Set-up Mode
Set-up mode enables you to customize the printer for your specific use. This
appendix contains a full list of the choices you can make for each feature of the
printer.
To change any of the features, perform the following steps:
1 Load the fanfold paper
2 Enter the Set-up mode
3 Select the feature to be changed
4 Select the value needed.
5 When all changes have been made, exit Set-up mode to store the changes
in the printer’s memory.
Any changes you make are stored by the printer when you exit Set-up mode.
If power is switched Off before you exit Set-up mode, the changes you made
will not be stored by the printer.
A.1.1 List of Set-up Features and Values
The value of each set-up feature is changed by moving through the list of
features until the desired feature is reached, and then moving through the
list of available values for that feature until the desired value is reached. The
list of features and their possible values is shown in the following tables. The
values marked with an "*" indicate the factory setting when shipped.
Set-up A–1