User guide

Note the following:
If the first value Protocol is set to DEC, only the DEC and Generic group
features are accessible in Step 3.
If the first value Protocol is set to X24, only the X24 and Generic group
features are accessible in Step 3.
If the communication is port-dependant, all features are accessible.
5.3.2 Saving New Values and Exiting Set-up Mode
Press the Set-up switch once to store your set-up changes in the printer’s
memory.
The printer automatically returns to print mode.
Note: If the power is turned off before the Set-up switch is pressed, no changes
are stored in the printer’s memory.
5.4 Protocol Selection
The protocol that is active at power-up is selected through Generic Feature 1 in
Set-up. When this feature is selected, the protocol is determined at power-up
by the following rules:
If the Port Selection feature is set to "Serial Port", the DEC protocol is
selected.
If the Port Selection feature is set to "Parallel Port", the IBM Proprinter
protocol is selected.
If the Port Selection feature is set to "Automatic", the first active port will
determine the selected protocol:
If the first active port is the serial port, the DEC protocol is selected.
If the first active port is the parallel port, the IBM Proprinter protocol
is selected.
After a protocol is selected, a new selection can only be done through
software commands, or through the Protocol switch on the control panel.
Configuring the Printer 5–5